INDUSTRY LINE

Crosspiece element with rigid barrel for internal passage of the cable and continuous sliding of the Sicur Delta shuttle PPE.

Device that allows you to anchor to a flexible horizontal line and travel the entire length without ever disengaging from the anchor point.
Device to be used with intermediate cable gland element.

Section divider element that allows the cable to make changes in direction at 90°. The curved cable gland is spaced from the vertical uprights to allow the shuttle PPE to slide continuously even if rotated by 90° with respect to the base plate.

Single packaging where the components necessary to form the TYPE C horizontal flexible lifeline are included, in accordance with the reference technical standard as well as laboratory tests.

Composed of:

ENERGY ABSORBER
AISI 302 Stainless steel with a helical shape, it has the function of dissipating the stresses induced by the fall of the user of the system, reducing the impact force on the end anchors. It is installed directly between the head of the support and the cable. It bears Sicur Delta marking on both forks to ensure product traceability.

TENSIONER
Two-welded forks with closed cantilever in AISI 316 stainless steel, necessary to obtain a correct adjustment of the cable tension. It is installed directly between the head of the support and the cable clamping terminal. In both threaded pins there are holes to affix the warranty seal. It bears Sicur Delta marking to guarantee product traceability.

CABLE CLAMPING TERMINAL
With internal ogive to ensure greater tightness than the tensile strength of the cable itself. in AISI 316 stainless steel Since the use of U-clamps is abolished by the product technical standard EN 795:2012, it is a system that increases its tightness with the progressive increase in the traction imposed on the cable. Laboratory tested both on the entire system and in tensile tests with only the cable installed.

WARRANTY SEAL
It shows the system number. It guarantees proof that the tensioner has not been used, therefore that the cable has not been uninstalled and reassembled by unauthorised personnel. At each inspection or maintenance operation on the system, its replacement with the registration of the new identification number proves that the check has taken place.

IDENTIFICATION PLATE
Necessary to record inspections or maintenance in permanent systems, any notes and system references.

INSTALLATION, USE AND MAINTENANCE MANUAL

AISI 316 Stainless steel cable with 8 mm rated diameter composed of 7 strands each of 7 wires.Supplied with one end already crimped, the other to be tightened during installation by means of the cable tightening terminal incorporated in the tensioner.
Identification and traceability of the product: to show the high quality and seal, the cable has inside a tape marked Sicur Delta; on the crimp made in the workshop are imprinted the registered trademark SD, the lot number of the cable and the dimension.